2000 series SPILLWAY HEADWALL

NOT STOCKED - MADE TO ORDER

This is a sectional structure with rebated sides, assembled on site around the drainage pipe and locked together by the means of stainless steel cast-in sockets and brackets provided. This headwall is designed for pipes with an outside diameter over 1000mm up to a maximum of 2000mm o.d. Three standard versions are available with wing walls at differing batter angles. Frimeda lift points are cast in.

Various types of heavy duty galvanised steel gratings or stainless steel gratings can be supplied which are bolted to the stainless steel sockets cast in. Brackets are available for use with the ground anchor system. Provision can be made for fixing tidal flaps, penstocks and other devices. All our precast headalls are made to order to suit the diameter and position of the pipes being used.

We can fit flow control devices to these headwalls at the customers request. Please see the options and extras page for more information.

2000 Series Dimensions

Max. Pipe Opening	Height Options Available (mm) A	B (mm)	Approx. weight (kg)	Maximum pipe size (mm)
900	1250	300	2600	750 ID twin wall  750 ID concrete
1150	1650	700	3200	1050 ID twin wall 1050 ID concrete
1800	2130	200	3600	1500 ID twin wall 1500 ID concrete

Installation

It is recommended that the unit should be bedded on 100mm of dry mix concrete. The drainage pipe to be entered through approximately 50mm unless fitted with flap valve and the gap around the pipe to be filled with cement mortar. Care must be taken when lifting precast headwalls, please read the HANDLING INSTRUCTIONS.

Ground Anchor

Where site conditions dictate, cables may be attached to the rear face of the headwall and tensioned to galvanized steel anchors buried a distance away to each side of the pipe.

Related Pages

• Custom options
• Gratings
• Handling Instructions
• 600 series Headwall
• 1000 series Headwall