Type X Silt Trap Inlets

Type X Silt Trap Inlet

Approximate weight: 1250kg.
For pipe sizes up to 750mm o.d.

A two-piece reinforced concrete unit with hinged grating and generous silt capacity. Any size of pipe opening up to a maximum of 750mm o.d. A hinged weed screen is normally provided for this unit. lift points cast in. When ordering please specify o.d. and i.d. of pipe to be connected and the overall height required.

IMPORTANT NOTE: Click here for handling instructions.

Type X Silt Trap
Maximum Pipe Openings (mm) 600830
A (mm) 1425 1730
B (mm) 400 to 700* 400 to 850*
Unit Weight 1250kg 1450kg
*In 150mm increments

INSTALLATION

The Heavy Duty Silt Trap should be installed on a level base. If necessary bed on 100mm of dry mixed concrete. The units should be lifted into position separately. Ensure that the drain pipe is flush or slightly protruding through the backwall. Use the four bolts through the brackets at each side to keep the units together for backfilling, do not over-tighten. Make good around the pipe with cement mortar, and clean out loose material from the floor before fitting the grating and its retaining brackets. Carefully complete the backfilling, and consolidate to the original profile.

Type X Silt Trap Inlet